Bad Z-Stepper Cable : 無料・フリー素材/写真
Bad Z-Stepper Cable / syvwlch
| ライセンス | クリエイティブ・コモンズ 表示 2.1 |
|---|---|
| 説明 | The wires are not in the right order, with the coils at 1&3 and 2&4. I swapped 1&4 and it turned out to result in the Z stepper running reversed. I just reversed it in RepG rather than change it again.To change the pinout without splicing cables, you can slide out the metal pins from the connector by gently pushing on the metal tab on this side while pulling on the wire, with the connector on the board. Gently!!!! |
| 撮影日 | 2011-06-13 08:37:58 |
| 撮影者 | syvwlch |
| タグ | |
| 撮影地 | |
| カメラ | Canon PowerShot SD3500 IS , Canon |
| 露出 | 0.05 sec (1/20) |
| 開放F値 | f/2.8 |
| 焦点距離 | 17777.77778 dpi |