Unicorn printing on a MakerBot Thing-O-Matic : 無料・フリー素材/写真
Unicorn printing on a MakerBot Thing-O-Matic / roberthunt1987
| ライセンス | クリエイティブ・コモンズ 表示 2.1 |
|---|---|
| 説明 | A bit of a hack involving an arduino to get the Unicorn working on the Thing-O-Matic but I hear Adam and the guys over at MakerBot are working on getting support into the next firmware release.Esentially I have an arduino hooked up to the fan header on the Extruder Controller v3.6 which is usually used for the ABP motor. The arduino listens for a low on the pin and actuates the unicorn's servo between 30 and 40 degrees based on the output. It was then just a case of replacing the servo commands to M106 and M107.The design is the MakerBot Exploded Diagram, orignally by James Provost and made Unicorn printable by mifga (www.thingiverse.com/thing:4401). |
| 撮影日 | 2011-01-23 12:08:00 |
| 撮影者 | roberthunt1987 , England, UK |
| タグ | |
| 撮影地 | |
| カメラ | DMC-TZ10 , Panasonic |
| 露出 | 0.025 sec (1/40) |
| 開放F値 | f/3.3 |