Plastruder MK4 assembly issue DSC_0614 : 無料・フリー素材/写真
Plastruder MK4 assembly issue DSC_0614 / s p e x
| ライセンス | クリエイティブ・コモンズ 表示-継承 2.1 |
|---|---|
| 説明 | Seems that the 16mm bolts are too long and the 10mm bolts are too short here. I suppose I will have to cut some to fit.UPDATE -- Careful inspection of some photos from the MakerBot group suggest that I can add washers and nuts on this side of those bolts to make up the difference. Perhaps I missed that in the instructions.UPDATE -- UPDATE -- I put off assembling the nozzle assembly 'till last, as it seemed somewhat intimidating compared to the rest of the bolting together assembling. But now that I've completed the process and added it, I've found that I can use the 14mm screws just fine and that they are pressing the nozzle assembly into the feeder assembly without putting the "disk" above flush against the feeder assembly.I will take another photo and show you.UPDATE UPDATE UPDATE -- OK, so there is a middle size bolt, but I hadn't noticed before. The only ones I could come up with came with the spare print surface. And now it seems that I might have put the middle sized bolts anywhere in the system. bah!UPDATE UPDATE UPDATE UPDATE -- OK, one of the longer middle bolts worked, but not a few others. See my improvisation here: www.flickr.com/photos/s_p_e_x/4617059689/ |
| 撮影日 | 2010-05-09 11:26:05 |
| 撮影者 | s p e x |
| タグ | |
| 撮影地 |