Skeinforge Battle 2: Round 1 : 無料・フリー素材/写真
Skeinforge Battle 2: Round 1 / Tony Buser
| ライセンス | クリエイティブ・コモンズ 表示-継承 2.1 |
|---|---|
| 説明 | This is a simple test object I've created that has parts that my makerbot typically has problems with. There is a 3mm hole through the center and a 2mm wall on the side.Started with the default settings from: wiki.makerbot.com/cupcake-skeinforge-usageChanges:Only change from the defaults was to increase the raft temp settings because I have a 1mm thermister and haven't changed the table on the board. I set them to:raft: 2501st layer outline: 2351st layer within: 235shape next layers: 240support layers: 240supported layers: 240Result:Major Blobbage. So bad it makes the extruder barrel flex as it drags over the blobs, so I stopped the print before it finished. |
| 撮影日 | 2010-01-07 10:29:29 |
| 撮影者 | Tony Buser , Reading, PA, USA |
| タグ | |
| 撮影地 | |
| カメラ | Canon PowerShot SX20 IS , Canon |
| 露出 | 0.033 sec (1/30) |
| 開放F値 | f/2.8 |
| 焦点距離 | 5 mm |